Just for a little variety from my black officer we tried out an ISB. I tried to get a close to off-white material as possible without going too grey but didn't find anything that satisfied me for coloration. I know debate on color for officers is an eternal discussion with varied opinions (particulary on the green/grey/white/ecru etc.). i decided to get something that I thought looked good in room lighting. These pics of course are in daylight.

The front panel need adjustment: The top corner part of the front flap should end horizontally with the bottom of the neckline.

Also the belt is reversed.

I'm bored today, so I drew it out to make it easier to understand

Thanks! I didn't know about the horizontal edge to the flap. Also, I heard that the cut is more angled to the center line of the torso than the regular officer? Is that correct?

Yeah the belt was a boo-boo. It was 104 degrees out in Florida when these pics were taken and I think i was delirious.

No code cylinders either? Or are they allowed under the assumption someone had to have them in the ISB?

I think your right, after viewing some pictures, it seems there are no code cylinders or pockets for them either.

Like this

On a second note, it looks like you could use that tunic for a grand admiral costume

I wouldn't worry about them. If your GML says "HEY!!! NO CODE CYLINDERS!!!!!!" then just take them out and retake the photo

His GML noted all the things noted here and sadly I have never seen his costume again. But he does look sharp even with a few oops. Zac has trooped in one of his many other costumes. I hope eventually this one does come back out with the corrections because we could use a few more of this one down in Florida.

As far as Code Cylinders go, the ISB tunics don't even have Code Cylinder pockets...