[North Texas GA Thrawn]

Hello and welcome aboard


Sent from my iPhone using Tapatalk

[Merr Sonn holster]

This looks like a Darman Props. If it's the case, they sre VERY high quality holsters. You will not regret it.


Sent from my iPhone using Tapatalk

[Cosplay Sky Fitting- Custom Measurement Fail]

Twice I ordered from them and twice i had to get my things fixed.

They did refund me the cost of my seamstress. And in less than 48h.


Sent from my iPhone using Tapatalk

[Congratulations to our new Detachment Leader]

Congrats Mark. The IOC is in good hands


Sent from my iPhone using Tapatalk

[Questions for Candidates]

Question to all candidates:

 

Do some of you have any experience inside the Legion, like, Garrison command, Squad command or other Detachment  commande or staff?

 

Good luck all, 

 

Eric

[IN-41800 Requesting Navy Trooper - Dress Executor Status]

Bonne chance Simon!

[My personal squad]

12 hours ago, Avatar190 said:

Yeah, the black with orange accents looks great...wish they were approvable.  :)4

It's actually candy red, the picture is not doing the armors justice. 

[Staff officer boots]

My biggest concern is they look a bit short. If they come up to your knees, they'd probably be fine. Unless the model wearing them has ridiculously long legs, they might be too short.

Thank you for your input. Much appreciated. 

 

Very hard to find size 12 and find something for a guy with bigger calves lol. I've seen some for reasonable prices, but, with transport and exchange rate to Canada, it comes close to 500-550$ CAD.

[Staff officer boots]

That's a tough one. The sole looks a bit thick and there is a slight sweep to the front of the top of the shafts. They still look like something out of the Star Wars universe.

I always recommend leather as I think it looks much better. These don't look too bad though. Good luck.

You are not convincing me, so I'll keep looking!

Thanks mate for the answer.

Eric

[Staff officer boots]

Hello IOC, 

 

      I was looking at these boots and was wondering if they can be good for basic approval. I don't want to go Level 2 and 3 for now. If I decided. I will need to get them custom made. 

Thank you for your help, 

 

Eric

IC-37427

 

 

[Com pad question]

I know this isn't really what you are asking. But if you can't get it to work I purchased a compad from this guy. It is very nice! Although it is lit up with LED lights. Not sure if you would want a light up one though. Hopefully you can figure yours out, otherwise here is a good alternative!

http://www.501st.com/forum/viewtopic.php?f=28&t=76351&hilit=ti3853

I have one on its way. I just wanted one for now. I might check to put some light in,just for the fun of it.

It doesn't look to accurate either.

[Com pad question]

Hello all, 

 

 

     I want to have the ROTJ look with my Crewman. For that I need a compad. While I'm waiting for a better one, I wanted to use an old one that I have. It came with a TIE Helmet that i bought. I was told it was a Jarvis helmet (resin). So I imagine, the Compad is a Jarvis too. I heated the compad up, but, event after 30 minutes in the Microwave in some water, I still can't bend it. To the point, one corner broke. Am I doing something wrong?

 

     Thank you very much for your help, 

Eric