DarthVadersLT

I'm working on the Krennic rain poncho cape CRL currently, and this couldn't be more right. Adding in specific numbers in instances where "this HAS to be 2 inches" is a load of malarkey. People are built differently, and ergo numbers on people will be different. The standard is the costume "has to be proportional to the wearer," which effectively makes numbers irrelevant. You come up with your own numbers. Shorter vs higher neck? Broad shoulders vs not having shoulders? Its all relative. I plan on adding a general ratio to the CRL for people to follow and use, but that's it in terms of numbers. Thoughts?

I'm working on the Krennic rain poncho cape CRL currently, and this couldn't be more right. Adding in specific numbers in instances where "this HAS to be 2 inches" is a load of malarkey. People are built differently, and ergo numbers on people will be different. The standard is the costume "has to be proportional to the wearer," which effectively makes numbers irrelevant. You come up with your own numbers. Shorter vs higher neck? Broad shoulders vs not having shoulders? Its all relative. I plan on adding a general ratio to the CRL for people to follow and use, but that's it in terms of numbers. Thoughts?

I took photos this morning outlining my ideas. I think it does justice. What do you guys think?
 
 
This one is just the standard plexi glass full rank bar I bought from Etsy I don't plan on using. Here it's used for scale, and the spacing of each tile/ends is 1/4 inch.
 
 
This is with my math work rank bar cut out, which is the same thing, it matches up pretty well compared to the rank plaque. It is also 1/4 inch spaces.
 
 
This is the cutout I did with 1/8 inch spacing. This I believe looks a lot more accurate. I don't have my tunic yet, it's still in development, but imagining the code cylinder pocket w/ the code cylinder in it, and the center yoke, this rank bar fits perfectly.
 
Thoughts?

I took photos this morning outlining my ideas. I think it does justice. What do you guys think?
 
 
This one is just the standard plexi glass full rank bar I bought from Etsy I don't plan on using. Here it's used for scale, and the spacing of each tile/ends is 1/4 inch.
 
 
This is with my math work rank bar cut out, which is the same thing, it matches up pretty well compared to the rank plaque. It is also 1/4 inch spaces.
 
 
This is the cutout I did with 1/8 inch spacing. This I believe looks a lot more accurate. I don't have my tunic yet, it's still in development, but imagining the code cylinder pocket w/ the code cylinder in it, and the center yoke, this rank bar fits perfectly.
 
Thoughts?

CRL photos taken today and a couple of special ones
 
Image resized to 74% of its original size [667 x 1000]
 
Image resized to 74% of its original size [667 x 1000]
 
Image resized to 74% of its original size [667 x 1000]
 
Image resized to 74% of its original size [667 x 1000]
 
Image resized to 74% of its original size [667 x 1000]
 
Image resized to 74% of its original size [667 x 1000]
 
Image resized to 74% of its original size [667 x 1000]
 
Image resized to 74% of its original size [667 x 1000]
 
Image resized to 74% of its original size [667 x 1000]



and saving the best till last

 
Image resized to 73% of its original size [683 x 1024]
 
Image resized to 73% of its original size [682 x 1024]